Senior Electrical Engineer with 8 years experience in the development, evaluation and installation of electrical assemblies and wire/harness systems. Expert in failure-mode analysis, troubleshooting and repair of electronics and electrical sub-systems. Strong ability to collaborate with international teams to develop engineering solutions for mission critical and industry leading technologies.
Experience in all phases of electrical system development, deployment and validation for aircrafts.
Expertise in hands-on electrical troubleshooting, failure mode analysis and electronic repair.
Certification in IPC/WHMA Standards.
Instructor and trainer in Wire/Harness system installation/validation & SMT/THT soldering and inspection.
Specialist training in assembly and repair of MIL-spec harnesses and connectors.
Programming of PLC and single-board microcontrollers for automation.
PCB prototype layout and design.
Lead Electrical Engineer for SAFRAN CABIN (Manufacture of Aircraft cabin interiors, systems and equipment)
>Responsible for all the production lines in electrical sub-system installation and inspection, leading and training team of over 50 technicians.
>In charge of all aspects of the electrical systems in the cross-functional team that submit engineering changes, product improvements and procedure revision.
> Reduced the installation defect rate of electrical installations in all models to 0% within 6 months of leading the project. the procedure changes are now adopted by all other sites in the country
Electrical Test Engineer for Sensata Technologies (Manufacture of sensors for aerospace, vehicular and heavy industries)
>Responsible for the electrical testing and quality assurance for all heavy industry sensors.
>Focal point negotiator for key-clients in warranty claims on field-used parts, expert in the improvement of electrical system design.
>Developed and deployed the electrical testing stages during new model introductions, with individual budgets of over 2M usd.
Electrical Engineer for Samsung Electronics ( Mass production of consumer grade TVs and monitors)
>Evaluated, deployed and repaired custom automation PCB-test hardware.
>Validated the new software revisions for TVs and monitors main boards, and generated their automated test procedures.
>Recognized as an expert in root cause analysis and repair of defective production units at the PCB level.
A builder and maker with a "dirty hands" approach. Handy with hand and power tools, as well as 3d printing, my personal interests are in miniature model building and prop fabrication.
